FIND YOUR REMOTE

Find your remote and compatable JMA Remote to copy

Legend: Click on the symbols for further information

Frequency

Type of code

  1. Fixed. The code emitted by the remote control, is always the same. There is no encryption and once the remote control is duplicated, the copy works directly in the receiver.
  2. Rolling. The code emitted by the remote control, changes with each pulse. A copy of the remote control should be made, that way generating the same brand and model but with a different serial number, that will be necessary for registry in the receiver. There are specific instructions for each receiver of either how to register the copy, remotely or directly manipulating the receiver.

Buttons

Auto-Programmable The remote control can be registered in the receiver without the need of the original remote control, as long as radio communication is activated and the memory is not full.

PROCESS:

  1. In front of the receiver keep the JMA remote control pressed during 10 seconds until the red LED goes off (after 4 seconds) and it turns to green (at 10 seconds).
  2. Once the LED is green, release the button and wait for the LED to definitely go off. During the process, the green LED will flash once or several times depending on the code type until finally going off.

If the process does not work, test the standard method using the original remote control or gaining access directly from the receiver.

Copy

No copy

STAGNOLI® KALLISTO

  • F 433,92
  • C ROLLING CODE
  • B 4
  • AP NO
STAGNOLI® KALLISTO

See compatible JMA remotes

STAGNOLI® VENUS

  • F 433,92
  • C ROLLING CODE
  • B 2
  • AP NO
  • M-BT / SIMPLY FR1
STAGNOLI® VENUS

See compatible JMA remotes

Synchronising intructions

Print

HOW TO SYNCHRONISE STAGNOLI ROLLING CODE REMOTE CONTROLS

STAGNOLI remote control synchronisation can only be performed directly on the receiver itself.

Synchronising the remote control directly on the receiver:

During start-up, LED1 and LED2 will light up for two seconds as follows:

• LED1 on: Variable code programmed.

• LED2 on: Fixed code programmed.

• Both LEDs on: no transmitter in memory.

Once the receiver is powered up, press the synchronisation button (PG) a number of times corresponding to the operation you wish to complete, holding down the button on the last press.

Synchronisation of the first channel on the receiver: Press the synchronisation button (PG) twice and hold. LED1 will blink twice: press the transmitter button you wish to synchronise.

If the new code has been recognised and synchronised correctly, LED1 will emit a long flash.

By holding the synchronisation button (PG), it is possible to synchronise additional transmitters by pressing the buttons (one at a time) on the additional transmitters to be synchronised.

Synchronisation of the second channel on the receiver: Press the synchronisation button (PG) three times and hold. LED1 will blink three times: press the transmitter button you wish to synchronise.

If the new code has been recognised and synchronised correctly, LED1 will emit a long flash.

By holding the synchronisation button (PG), it is possible to synchronise additional transmitters by pressing the buttons (one at a time) on the additional transmitters to be synchronised.

STAGNOLI® ZEUS

  • F 433,92
  • C FIX CODE
  • B 3
  • AP NO
  • BASIC / M-BT / SIMPLY FR1
STAGNOLI® ZEUS

See compatible JMA remotes