HOW TO SYNCHRONISE PILOT SPACE ROLLING CODE REMOTE CONTROLS

PILOT SPACE remote control synchronisation can be performed either directly on the receiver itself or remotely using a remote control that is already synchronised with the receiver.

Remotely synchronising the remote control on the receiver

You must enter each transmitter button separately.

Depending on whether the transmitter / pilot button is to control channel 1 or 2, use the corresponding button on the radio card / control panel / receiver to enter the programming procedure.

1. Press and hold the \"1\" button on the radio card / control panel / receiver for 2 seconds (if the programmed transmitter / transmitter button is to operate channel

1) or the \"2\" button (if the programmable pilot / transmitter button is to operate channel

2). The LED will flash.

2. Within 20 seconds press the button of the transmitter / transmitter to be entered - the LED briefly illuminates with a continuous tone, indicating that the correct pilot / transmitter signal has been received. 3. To accept, press the \"CLR\" button on the radio / control panel / receiver or wait until the LED goes For further buttons on this or other remote controllers / transmitters, proceed as per section 1-2-2 WARNING! - To edit the remote control / transmitter button configuration by deleting the channel assignment to the button, remove the remote control / transmitter from memory (point III), and then re-enter the buttons in the desired manner. Attempting to enter 16 remote control / transmitter will fail.

Synchronising the remote control directly on the receiver

It is possible to enter pilots / transmitters without having to access radio buttons / control panel / receiver. To do this, you must have a transmitter already in place, with the button configuration you want to get in the next (new) pilots / transmitters.

1. Press and hold any pre / programmed remote control / transmitter button for 20 seconds.

2. Within 20 seconds press any button on the transmitter / transmitter to be entered / programmed. In order to enter more transmitters, follow the instructions. point. 1 and 2

WARNING! - The procedure for simple entering pilots / transmitters adds a new remote control / transmitter and sets its buttons according to the pre-programmed transmitter / transmitter configuration used in this procedure.

For the simple procedure of entering the transmitter successfully, the distance between the transmitter / transmitter and the receiver / control panel should not exceed 20 meters.